Well, todays been a long day of tunning and such. My friend and I were trying to tune the engine perfectly so that it would not stall nor over heat. Of course we found some problems.
1.) On speeding up to high RPM's and we think when it hits the shift point, the just engine stops dead. Now we adjusted the pin (HighSpeed) to a point so when we accelerated the engine didn't stall, but we were wrong, it still dies!
2.) Coming from a high speed return, when the brakes are put on the engine died. However, the engine doesn't turnoff when we coasted around corners and did not use the brakes.
The temperature outside was about 65F if that helps with the solving of these problems. I have asked people at my local hobby shop and they said to loosen up the brakes. Now the only reason why that could be a problem is when you hit the brake it completely cuts of the gas to the engine.
Any help would be good, I'm kind of new to this hobby so a decent explanation would be good.
Thanks!
1.) On speeding up to high RPM's and we think when it hits the shift point, the just engine stops dead. Now we adjusted the pin (HighSpeed) to a point so when we accelerated the engine didn't stall, but we were wrong, it still dies!
2.) Coming from a high speed return, when the brakes are put on the engine died. However, the engine doesn't turnoff when we coasted around corners and did not use the brakes.
The temperature outside was about 65F if that helps with the solving of these problems. I have asked people at my local hobby shop and they said to loosen up the brakes. Now the only reason why that could be a problem is when you hit the brake it completely cuts of the gas to the engine.
Any help would be good, I'm kind of new to this hobby so a decent explanation would be good.
Thanks!