will this work????

[ozz_man89]

http://www.stormerhobbies.com/cgi-bin/seekpart.pl?pn=S18TX

will this .18 for the MAXX fit into a new rusty??????? i was browsing the stormer hobbies page and ran across this motor.

 

[x_789]

Ok I am not sure about the crank that you use on Rustler but on a T-Maxx and N-Pede they use a Short crank. Now when you look at the picture they show and SG shaft in the picture that is the long crank.

Then read down the discription it states

No crankshaft to cut

If thats the case then there would not be an sg shaft for it to fit on a T-Maxx anyway if you use a short crank in a Rustler then the motor should drop right in if its a 2.5 Rustler. Still I dont know why you would want to do that because a 2.5 rusty is already very much overpowered. Thats not bashing that is fact so please dont flame. X

 

[ozz_man89]

thanx X