So I was having issues with my WLtoys 144001 2in1 ESC.. Told me to upgrade so I did reconsider since I had a crash (didn't take photos) and bent my drive shaft so I ordered the part... And some other...
In this upgrade, I used the following parts... Along with some 3D printed modifications found in www.thingiverse.com
Transmitter : DumboRC x4
Receiver : DumboRC X6F
ESC : Surpass Rocket 60A ESC (wondering how'd it fit)
Brushless Motor : Surpass Hobby F540 3930KV
Servo : Surpass Hobby 17g Digital Servo (Same size as stock. Pretty Small eh?)
Battery : Zippy 2200 mAh 3s LiPo
Now for some cable management....
Then I tried fitting the battery... Oh Lord...
I don't know how am I supposed to secure my battery... But it snugly fits in there and luckily....
My 3d printed cowl / cover secures it a bit. Just a bit... I added a thin foam sheet on the side of it to add a little more security heh.. And finally....
It's DONE! That's the only 3d Printable body I could find that is FREE. I think Imma go change this bumper...
In this upgrade, I used the following parts... Along with some 3D printed modifications found in www.thingiverse.com
Transmitter : DumboRC x4
Receiver : DumboRC X6F
ESC : Surpass Rocket 60A ESC (wondering how'd it fit)
Brushless Motor : Surpass Hobby F540 3930KV
Servo : Surpass Hobby 17g Digital Servo (Same size as stock. Pretty Small eh?)
Battery : Zippy 2200 mAh 3s LiPo
Now for some cable management....
Then I tried fitting the battery... Oh Lord...
I don't know how am I supposed to secure my battery... But it snugly fits in there and luckily....
My 3d printed cowl / cover secures it a bit. Just a bit... I added a thin foam sheet on the side of it to add a little more security heh.. And finally....
It's DONE! That's the only 3d Printable body I could find that is FREE. I think Imma go change this bumper...