Rdizz
RCTalk Basher
- Thread starter
- #41
It's a process lol. Thanks again for everyone's help Will fiddle around some more tomorrow and report back. Talking to "real life" people always much more enjoyable than support lines. And learning is half the fun of this hobby eh...That vid looked much better, notice how on braking the carb slide isn't being pushed into the body.
Yes to set the idle gap, pop the throttle linkage off the carb slide, set the idle gap, using light pressure on the slide using your finger, put linkage back on and check the operation.
The gap should not change on braking, if it did then adjust the little collars on the linkage.
It looks like you got the pushing in on braking sorted out.