Nedly
RCTalk Qualifier
- Thread starter
- #41
This is what I got for a glow starter..
These are the glow plugs. The A5 is the smaller one on the left..
This is the carb. It seems that the high speed needle is the valve on the line? I have never seen a finger twist design for a needle, it could be the low speed or high speed I do not know. I found the idle screw, and right above it is the larger carb screw (low speed?), I started with it flush to its housing and worked in from there. But I still get no attempt to fire no matter what, so I am thinking it is the glow supplies.. I did have the engine in the truck, but I took it out and mounted it to a board just to try and start, figured if it started I would re-install it to tune it...
These are the glow plugs. The A5 is the smaller one on the left..
This is the carb. It seems that the high speed needle is the valve on the line? I have never seen a finger twist design for a needle, it could be the low speed or high speed I do not know. I found the idle screw, and right above it is the larger carb screw (low speed?), I started with it flush to its housing and worked in from there. But I still get no attempt to fire no matter what, so I am thinking it is the glow supplies.. I did have the engine in the truck, but I took it out and mounted it to a board just to try and start, figured if it started I would re-install it to tune it...