REVO-5309
Hardcore RCTalk User
Hey, i was trouble shooting a problem with starting my revo. the electric starter was just spinning after the motor done one to two rotations. so i ended up cleaning up around the one way bearing and then using some very fine sand paper to roughen up the shaft as it looked like it was spinning. and after i did that it was spinning fine but then after trouble shooting why it wasn't starting again it seemed the glow plug wasn't heating up at all, tested a few other glow plugs with the same problem.
so i tested some more with the earth and what not and the problem seems to be on the circuit board as the lights indicate that the glow plug is working but there is no glow. any ideas on what has blown and how to separate the circuit board and the button from the wand?
with this all happening I'm in the process of making an order from the states to Australia with a whole heap of little things so iv chucked in a pull start and a glow plug igniter. but ill only put those on if the wand can't be fixed by some simple soldering and what not.
so i tested some more with the earth and what not and the problem seems to be on the circuit board as the lights indicate that the glow plug is working but there is no glow. any ideas on what has blown and how to separate the circuit board and the button from the wand?
with this all happening I'm in the process of making an order from the states to Australia with a whole heap of little things so iv chucked in a pull start and a glow plug igniter. but ill only put those on if the wand can't be fixed by some simple soldering and what not.