REVO-5309
Hardcore RCTalk User
so my trx 3.3 motor is starting to loose a bit of compression. i pulled the motor apart and the rear bearing is getting a bit loose and the brash bushing on the rod got a bit loose. so for now iv turned the rod around. when i went to put it all back together i cracked the carb where the HSN goes in when i done it up (bit too tight) when i put it all back together tho it seems there is less compression that before. any reason for this and or will running it once i get a new carb fix this? just before i pulled it apart the low end started to loose power, wasn't doing wheelies apart from when it was just started from being cold. as it got warn it stopped doing wheelies. would that have something to do with compression?
with this in mind, deciding weather i rebuild the trx 3.3 with new piston, sleeve, rod, carb and bearings. or to just get a picco .26 jl red dot...
with this in mind, deciding weather i rebuild the trx 3.3 with new piston, sleeve, rod, carb and bearings. or to just get a picco .26 jl red dot...