I have it on a crawler, so it is hard to tell when it is on 50% power. My min voltage on the battery label is 6 volts. I am paranoid.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Ok, I thought that it was mean the battery was permanently ruined when the cutoff was activated.It simply means that the model will be dead until the battery is charged again. No position of throttle will allow the model to move again.
What would be a good device that would make a noise when it gets to something like 6.5 volts?lvc does not harm battery.. it protects the electronics on the rc... but the 6 volts is way to low of a voltage to take a 2 cell lipo to(you will have to bring each cell up on nimh mode at 1 amp charge thru balance wire..
I never have gotten he battery down to 6 volts or ever had the cutoff activate. I have this charger https://www.amainhobbies.com/radient-reflex-lipo-20w-balance-charger-us-rdna0066/p501582you see a lipo will have what i call a bounce back voltage (varies from pack to pack) but its about .02 volts max o stop at 7.0 volts when you check battery after a few minutes voltage will be a little higher than the 7.0 volts alarm was set at.
Who the hell was THAT?It simply means that the model will be dead until the battery is charged again. No position of throttle will allow the model to move again.
?Who the hell was THAT?
I'm messing with @WVNed. Haven't seen him here in quite a while.