uberbricky
RCTalk Basher
So I acquired a full FLM Emaxx today, it's always fun seeing how someone else put something together...anyways here is the list:
Full FLM Chassis
2200kv CC
150A Hobbyking ESC
RPM Carriers
Random dogbone CVDs all around
24mm hubs
Some kind of aluminum shocks
Ridiculous aluminum bumpers
Here is the pics:
As always, I have to go through it and see what kind of mess is there...started with the rats nest of a power harness...
Taking out the HS-645MG used as the steering servo (???) cut the tie holding it on (???) and found a wire that was spun together:
Took the motor, esc and rx off also, installed a bigger steering link and better servo:
I decided that two sided tape doesn't cut it for holding down the ESC... so threw together a couple mounts, and I'll make a carbon fiber hold-down tomorrow:
It worked out perfectly using some fuel line at the top to tighten against.
Can anyone identify the shocks, especially the front ones, not sure why there is no springs on the back two? Also what is a good radio case to use on these chassis?
Thanks!
Full FLM Chassis
2200kv CC
150A Hobbyking ESC
RPM Carriers
Random dogbone CVDs all around
24mm hubs
Some kind of aluminum shocks
Ridiculous aluminum bumpers
Here is the pics:
As always, I have to go through it and see what kind of mess is there...started with the rats nest of a power harness...
Taking out the HS-645MG used as the steering servo (???) cut the tie holding it on (???) and found a wire that was spun together:
Took the motor, esc and rx off also, installed a bigger steering link and better servo:
I decided that two sided tape doesn't cut it for holding down the ESC... so threw together a couple mounts, and I'll make a carbon fiber hold-down tomorrow:
It worked out perfectly using some fuel line at the top to tighten against.
Can anyone identify the shocks, especially the front ones, not sure why there is no springs on the back two? Also what is a good radio case to use on these chassis?
Thanks!
Last edited: