The motor for my B74.1 should be here today. Naturally it will be going straight in the buggy on arrival. I’ve looked at a few videos on wire routings etc. and all of them show the motor wires soldered to BOTH the ESC and the motor. I don’t really like the idea of them being “permanently” attached. For cleaning or motor changes whatever.
My question is: Would it be a bad idea to solder some 4mm sockets directly to the motor tabs and 4mm bullets on the ends of the wires? I’m not worried about the sockets staying in place, I’m pretty good at soldering. Just not sure why all the pros seem to go with the direct method.
Here’s where I’m at so far. Pretty happy with how neatly everything fits.
My question is: Would it be a bad idea to solder some 4mm sockets directly to the motor tabs and 4mm bullets on the ends of the wires? I’m not worried about the sockets staying in place, I’m pretty good at soldering. Just not sure why all the pros seem to go with the direct method.
Here’s where I’m at so far. Pretty happy with how neatly everything fits.