beentryin RCTalk Basher Messages 45 Reaction score 0 RC Driving Style BashingRacing Jun 12, 2011 #1 theres a notch on your piston like a square cut does that go toward exhaust or intake?
E Extreme RC Mods RCTalk Vendor! RCTalk Vendor Messages 743 Reaction score 8 Location Canada RC Driving Style BashingRacing Jun 12, 2011 #2 Towards the main bearing, if you happened to do the rod then the little holes drilled in it should face the same way.
Towards the main bearing, if you happened to do the rod then the little holes drilled in it should face the same way.
beentryin RCTalk Basher Messages 45 Reaction score 0 RC Driving Style BashingRacing Jun 12, 2011 Thread starter #3 so that would be towards the intake correct?
MAXXcrasher RCTalk Basher Messages 58 Reaction score 0 RC Driving Style Bashing Jun 12, 2011 #4 u want the notch towards the intake so it pulls the fresh fuel and air into the cylinder... if u take off the header with the piston at TDC you shouldnt be able to see the con-rod
u want the notch towards the intake so it pulls the fresh fuel and air into the cylinder... if u take off the header with the piston at TDC you shouldnt be able to see the con-rod
beentryin RCTalk Basher Messages 45 Reaction score 0 RC Driving Style BashingRacing Jun 12, 2011 Thread starter #5 cool thanks a bunch just wanted to make sure it was in right