corneileous
RCTalk Champion
Hey guys, odd question.... Not sure if this is the proper area of the forum to post this but I have a Revo 3.3 that I'm trying to install some CV axles from a E Revo 2.0 and I found out that the differential output shafts for the 2.0 are a larger diameter than the ones on my 3.3 and the new drive cups for the axles are a lot bigger than my differential's output shafts.
The only options I can think of is try is 1, find some steel bushings that were around a quarter of an inch long and were 7.9mm OD by 5.8mm ID or 2, try my luck with the drive cups for the metal CV axle upgrade for the Revo 3.3 if they're not too small for these axles.
Any ideas?? Thanks.
The only options I can think of is try is 1, find some steel bushings that were around a quarter of an inch long and were 7.9mm OD by 5.8mm ID or 2, try my luck with the drive cups for the metal CV axle upgrade for the Revo 3.3 if they're not too small for these axles.
Any ideas?? Thanks.