ok i have rewritten my post cause it seem incomprehensible.
i have an 2.5r revo and yesterday it was working fine today i wasn't able to get it started the engine always seem to get stock on TDC.if i remove the glow plug or really slack it the pistonwill move with the easy start but if the glow...
Well I got my revo and the front shocks seem perfect but the rear feel like they need shock oil they are all stock but what weight oil should I use for the rear?
Hi everybody,
My traxxas revo 3.3 engine stops immediately after releasing throttle. It does not idle even for a few seconds.it is 3 years old but has not consumed more than half gallon of fuel. When i start the engine if i push throttle on the radio it moves fast enough but when i release...
I have a revo 3.3 I got from my brother-in-law who blew the engine put in a new engine and put on new clutch shoes meshed the gears correctly but it has no torque tightened the spur gear but still no low end torque
Watching this video made me realize I have a much wider variety with choices of body kits for my Savage X.
RC Modify 2 | HPI Dodge Charger Body on Traxxas E-REVO - YouTube
Well done, on his paint job.
Chas
ChasCS
Thread
batteries
charger
electric rc
hpi
monster truck
traxxastraxxas e-revotraxxasrevo
This was originally a 2.5 Revo and it does have the short chassis, everything is in good working condition unless noted below.
Axial 2.4 2ch TX/RX
Steering and throttle servo's are Traxxas 2075's
Single steering with proline aluminum arm and saver
THS pipe and header
Picco max .26 with just...
I recently picked up a used Revo 3.3, it has integy skid plates other than that it is stock. I'm looking to make it a full race redo, it currently has the LT rockers and looking to get new rockers not sure to go with the p2 or what, and what brand, also want to do the single steering servo...
I picked up a used erevo today and not even thinking about it didnt take my batteries with me. I ran it on his and when I got home my batteries dont fit. I didnt want to put any extra money in it so I would rather just turn it around.
The truck runs as it should. Its pretty clean but has...
bgbdwlf2500
Thread
brushless
electric rc
monster truck
rtr
traxxastraxxas e-revotraxxasrevo
Well, Racer 1966 finally spooled up the mill and spit out a mount. He used my New Era BB leaner mount as a starting point.
I installed his last weekend with a new LRP28S3 with pull-start (standard big block) and a new THS rear BB pipe. I didn't care for the THS header as kit kicked the header...
i have a bit of an overstock of parts that i dont need and would like to move them on to someone that could use them
first of all i bought a parts lot off my lhs of a slayer and have some left overs,prices exclude ship,discount for multiple item and will take best offer
1.slayer/revo 2.5...
so i got some more parts last night one of which was the slayer gear set to convert a spare revo trans to cut down my costs but i have now found out that there are 2 different tranny cases 5391r is the slayer case and 5391x is for the revo.When i tried to install the slayer equiped gear set...
Day one with the new to me Revo! It's the original short chassis version with a 3.3. I bought it off fleabay and got better than expected. I pulled it out of a well packed box charged the batteries put fuel in it and it started and ran great...Thats a surprise! On tank two I was running it hard...
Pulled her out and started doing some more modding. Really just cleaned her up. Added a new THS exhaust, more RPM upgrades, and a new body. Painted by a local RC enthusiast.
I have a revo 5309 running the two steering servo setup and its running ppp servos. steering is great servos move tires on ground setting still no problem but when your running it the center is constantly messing up. Would a glitch buster fix this issue
So while shopping I'm gonna new CB and clutch system and replace the spur also. So I'm looking for a real good gear setup for my revo with the picco engine? And also i was looking at this clutch setup wondering if its a real good part. I'm actually looking for pretty stiff springes,which i would...
I recently rounded off one of my hubs on my revo 2.5R and need to get new ones, as I was searching on ebay I saw a Kyosho offset hub kit, Part # KYOIFW328BL.. Would this fit on my truck?
I would appreciate any help, Thanks
Here is the Ebay link...