Hi guys,
Yesterday I went out to break in my LRP .28 spec 4 engine on a starter box, the piston moved a few times, then became stuck at TDC, I got it free, then when trying to turn the flywheel by hand, its very hard to get it past TDC. Now the box won't even turn it all all, just wears the wheel down, new engine having too much compression? Or something else?
Any advice, I'm grateful
Marty
Yesterday I went out to break in my LRP .28 spec 4 engine on a starter box, the piston moved a few times, then became stuck at TDC, I got it free, then when trying to turn the flywheel by hand, its very hard to get it past TDC. Now the box won't even turn it all all, just wears the wheel down, new engine having too much compression? Or something else?
Any advice, I'm grateful
Marty