Today, I decided to upgrade my Redcat Gen8V2 stock Hexfly servo to a old Hitec hs7950th. I've had this on my Axial ZR10 comp crawler for the past 10 years. This was the servo of choice for comp crawlers back then.
I'd set up endpoints with my Skyfly transmitter, and the first test run, everything went fine. After about 5 minutes of use, the steering went fully left and wouldn't turn back right at all.
So, I removed the servo horn, turn the power back on to let the servo reset to neutral, and remounted the servo horn. I tested it while the rig was on the stand. Now, every time I turned it left, it would reset slightly left of the neutral position. It would keep resetting back further and further left until the wheels maxed out to the left. I again repeated the same mounting and remounting procedure, but it still did the same thing.
Any ideas what's going on?
@Greywolf74 @WickedFog
I'd set up endpoints with my Skyfly transmitter, and the first test run, everything went fine. After about 5 minutes of use, the steering went fully left and wouldn't turn back right at all.
So, I removed the servo horn, turn the power back on to let the servo reset to neutral, and remounted the servo horn. I tested it while the rig was on the stand. Now, every time I turned it left, it would reset slightly left of the neutral position. It would keep resetting back further and further left until the wheels maxed out to the left. I again repeated the same mounting and remounting procedure, but it still did the same thing.
Any ideas what's going on?
@Greywolf74 @WickedFog