What needs work?

[SchrodeMode]

I was looking at my RC stable and noticed that it was turning more and more into a collection of parts rather than cars. Here's my list, some of these were never in a RTR status since I've owned them but most have been abused and then cannibalized to get others running.

Losi XXL- Needs new diffs
Jato- Needs engine & pipe, body
Rustler- Needs upper & lower chassis, steering bellcranks
Nitro Sport- Engine installed, transmission rebuilt, shocks put on and a body
T-Maxx- Screw set, transmission installed, engine, screw for the brake hex and a body
Bandit- ESC, shocks and body
Mini 8ight- ESC needs battery connector soldered on, install new ESC/motor convert spur over to the 48 pitch from Traxxas' mini lineup.
Micro Baja- Motor
MCX2- Servo gear
MSRx- Swashplate & main rotor hub
Nano CPx- New ESC/rx combo (better to buy a new heli)


How's the health of your fleet?

 

[HPIguy]

I'm pretty good about keeping most of them up and running, just in case the urge strikes.



Crawler - has sat on a shelf for about four or five years now, just wasn't my thing after building it. Runs fine though

MERV - perfect health, have yet to even break anything, even doing stupid stuff. By far my favorite RC ever.

VMX 450 - needs master link, should be here any minute now.

Octopede - Needs an E clip on one of the hinge pins, I'm out of them. Probably going to order threaded pins anyway.

Micro T - running great

Nitro RS4 - It's nitro, so I haven't touched it in years either due to fuel cost here.

T Rex 450 Pro - flying great

Blade 130x - needs some AS3X tweaking, but flying fine

MSRx - flying fine

MCP X - in a box, in pieces from a gymnasium wall collision

MQX - flying fine

F 450 acro quad - flying great, so much fun!

Flip FPV quad - flying great, flying tomorrow morning actually

 

[SchrodeMode]

I'm pretty good about keeping most of them up and running, just in case the urge strikes.

I was as well...until I got over here, then I started putting a "list" together of the parts I needed but I never ordered them. Now I decided to pick up another Mini 8ight and a XXXS for running on road, so my parts list will be put off for a little while longer lol. My bashing buddies all run on road at a local track (just for fun), so I decided to pick this up to run with them.

 

[hamz9561]

dNano Corvette C6R-Ready to go
dNano Audi R7-Ready to go
MiniZ MR03 Corvette C5R - Ready to go
MiniZ MR03 Mercedes C6.3 AMG - Ready to go
RC-18R - Ready to Roll
RC-18T - Waiting on New Shell
Mini Rock Crawler - Needs Battery Connector Soldered
mERV - Needs Cleaning (that one's for Rolex)
SCX-10 - Ready to Roll
Revo 3.3 - Waiting on conversion kit
Baja 5b - Waiting on RX pack
Nano QX - Waiting on 4-In-1 board
mQX - Ready to Fly
Scout CX - Ready to Fly
mCX - Ready to Fly
mSR - Ready to Fly
mSRx - Ready to Fly
UMX T-28D - Ready to Fly

 

[nitro_newbie]

Let's see.....
RC8be- currently running minus ESC fan
Sc104x4 no battery mounts
Scx10-only 5 days old/awesome!!
Hpi Baja 5t - works great!
Savage xs ss - works great
Night vapor plane- broken motor mount + no landing gear, I still fly it though!
Xeida 9958 - flies great !

Sent from inside a whale...help.

 

[Alexander_0_1]

Savage 25: runs great, having hard time getting fuel and parts to keep it a 25.
Savage x: runs even better with picco .28 drop in, xl driveline upgraded, no fuel!
Savage xl: needs more buku clutch pads, another vented clutch bell
FLM savage: needs gas tank, waiting for I-R/C V3 baja shocks, engine modding!
MERV: run perfect, waiting on alloy shocks, stiff springs, alloy suspension rockers, alloy shock mounts, new chassis so I can dye it black, or red
Mini P-51 mustang has too much dust, can't reach it, shelving is too tall.