I've got an RS4 and I need to remove the motor to clean out some stuff, but this thing won't come off, these screws are in VERY tight. Any suggestions on how to get them loose? Thanks
Heat the engine up,and figure out a way to cool off the screw's,that should loosen it up,or if it's rusted or dirrt as heck,try wd-40 on them,or you can just pry pry pry till they come off but they might break,those are the only suggestion i have.
If the head is stripped, you can cut a slot in the head with a Dremmel tool and a cutoff wheel. Then you can use a standard flat head screwdriver to get them out.