- Messages
- 6,376
- Reaction score
- 10,662
- Location
- Baltimore
- RC Driving Style
- Bashing
- Racing
- Crawling
- Scale Builder
Turned on the slash today. The motor clicked on as normal, but it wasn't as loud, it was a very faint clicks. I also re calibrated the ESC. The fan was not working. Hooked up my LCD programmer which uses the same port as the fan, and it didn't turn on.
Right now since I wanna run the car, I have the ESC fan running off receiver power by a servo extension.
So I think the program / fan port is dead? No voltage getting to it? I did buy the combo from hobbywing direct back in September. Emailing HW support while at it.
I tried to program from the direct ESC wire that plugs in the receiver, LCD programmer did turn on but programing did not work.
Right now since I wanna run the car, I have the ESC fan running off receiver power by a servo extension.
So I think the program / fan port is dead? No voltage getting to it? I did buy the combo from hobbywing direct back in September. Emailing HW support while at it.
I tried to program from the direct ESC wire that plugs in the receiver, LCD programmer did turn on but programing did not work.