mzanzirc
RCTalk Champion
As I am on the lookout for a abandoned/barn find nitro car, what would the best course of action be for a engine that has been standing for years?
Whenever I find one, for me I will first yank off all the old fuel lines, replace the glow plug and go over the electronics. But what about the engine? Should I pull the engine and take it apart? Or after replacing fuel lines and glow plug attempt to just start it?
I watched some of the RCBiker videos and if the engine is stuck, heat it up ect to get it loose seems like a good way to loosen up the engine.
Any suggestions welcome.
Whenever I find one, for me I will first yank off all the old fuel lines, replace the glow plug and go over the electronics. But what about the engine? Should I pull the engine and take it apart? Or after replacing fuel lines and glow plug attempt to just start it?
I watched some of the RCBiker videos and if the engine is stuck, heat it up ect to get it loose seems like a good way to loosen up the engine.
Any suggestions welcome.