SMaxxin
SLAP YA MAMA
Supporter
Anybody used it on the 1:1? I'm thinking about plasti dipping the wheels on my truck but I'm not 100% sure yet. Earlier today I grabbed an old piece of metal and did a test run with plasti dip with a shiny clear coat. I didn't warm it up or shake it enough so it's not the smoothest but not bad. I read something interesting about plasti dip that I didn't know so I tested it. You can lay down a coat then let it completely dry but every time you add a coat the previous coats that were dry will be wet again. I laid down two coats and let them dry, when I added the third coat I rubbed a small area and it was wet all the way down to the metal. This should make removing masking easy without worrying about peeling up the dry lays.
Three coats of plasti dip and two coats of clear, I put the last coat of clear too thick.
Three coats of plasti dip and two coats of clear, I put the last coat of clear too thick.