Revo Rancher
Hardcore RCTalk User
For anyone that has bought the new aluminum hollow turnbuckles for the Revo, there is a slight mistake in the directions.
The directions state to make them the size of the picture template or 6 inches. This ends up being too short. After I made up one of the rear ones, I installed it and noticed the rear tire was sitting with about 2 degrees of toe out. I then took it off again and matched the length to the turnbuckle I took off that corner. Had to make the turnbuckle longer by about 3/16's.
The directions state to make them the size of the picture template or 6 inches. This ends up being too short. After I made up one of the rear ones, I installed it and noticed the rear tire was sitting with about 2 degrees of toe out. I then took it off again and matched the length to the turnbuckle I took off that corner. Had to make the turnbuckle longer by about 3/16's.
Last edited: