Good afternoon to all-
A little while ago fool fashion, I bought an XK A160 Skylark rtf plane. it looks so good, and even though it was a pain to assemble with the very poor instructions, i got it together and it fired up and controls worked fine.
I took it out and on first flight, it went into a spin and crashed- just as the majority of this plane do.
since then, it will not bind and respond to control. I get a slow beeping sound from the plane, the controller starts up and shows input going to the plane, but there's no connection.
Can any of you good folks offer help? Is there a wiring diagram for this plane to check to see if a connection is loose- or do I just have a nice bright yellow wall-hanger?
thanks for your help- Ed
A little while ago fool fashion, I bought an XK A160 Skylark rtf plane. it looks so good, and even though it was a pain to assemble with the very poor instructions, i got it together and it fired up and controls worked fine.
I took it out and on first flight, it went into a spin and crashed- just as the majority of this plane do.
since then, it will not bind and respond to control. I get a slow beeping sound from the plane, the controller starts up and shows input going to the plane, but there's no connection.
Can any of you good folks offer help? Is there a wiring diagram for this plane to check to see if a connection is loose- or do I just have a nice bright yellow wall-hanger?
thanks for your help- Ed