Helppp

[Mido]

Hey,
i jsut did my break in but I'm not sure if its ok,
2 tanks let it idle..
Then next 3 i just varied speed and did figure 8's
This is wat HPI told me to do.
I did it and then i noticed a progress like when i press gas it doesn't cut out..
The only thing is now, when i slow down and then elave it a while it cuts out or,,, if i floor it it also cuts out..after couple of hours of use itll work right? Lemme now wat to do now. lol
Thanks all i really appreciatre ur help...

 

[Nitro RC Basher]

everythings good. what i did was run 5 tanks after the initial 4-5 just in case. then get it to running temp and tune

 

[hpiracing1123]

the factory likes 2 run the trucks rich so u can just lean the high and low speed needle out alittle bit.

 

[panpan]

it sounds like your low speed needle is too rich. try leaning it out when you're ready and see what happens