Sold / Found Futaba 3PM FASST 2.4GHz

[1NitroDude]

This is a like new condition, 3-Channel Radio Futaba 3PM FASST 2.4GHz, only used a few times, comes with Futaba R603FF 3 Channel Receiver in its original box and manual. I'm asking for $125. Sorry, No Trades. Thanks for looking! - Joe

Features:
L.C.D. Display Screen
Steering EPA
Throttle EPA
Steering D/R
Mechanical ATL
Battery Indicator
10 Model Memory
Programmable Mixing
3 Character Model Name

SOLD!

 

[Racer 1966]

Need to post a price please. Some description would help too,NIB or used/taken care of in original box?

 

[weezracen]

That is one good deal!

 

[frickenjoey]

Those are pretty good radios. I have one as a back up to my 3PKS. Great radio for getting into the 2.4 world.

 

[mgtrider08]

do you still have this?

 

[h8z2luze]

Is it a 3 pos. 3rd channel?

 

[h8z2luze]

yes but is the 3rd channel 2 position or 3?

 

[1NitroDude]

do you still have this?

Yes I Do!

yes but is the 3rd channel 2 position or 3?

Hey h8z2luze, I was browsing through the instruction manual and on page 45, there is a section on Channel 3 Position/CH3. So my guess is that yes, it does have it.

 

[frickenjoey]

I am pretty sure it is a two position 3rd channel. The switch that runs the third is basically an on/off switch that has adjustable servo end points.

 

[slowngreen]

If this is the same radio then it might be 3ps.

http://www.rccrawler.com/forum/showpost.php?p=1974428&postcount=100

 

[1NitroDude]

If this is the same radio then it might be 3ps.

http://www.rccrawler.com/forum/showpost.php?p=1974428&postcount=100

The Futaba 3PM-MX is the new version that just came out with three new Features; Four Wheel Steering Mixing, Digital Trim Step and Adjuster for Crawlers, Monster Trucks and any four wheel drive vehicle. These features allow drivers to apply mixing between steering, throttle and channel 3. Besides that, everything else is the same.

 

[ragedmx]

question

this work w/ normal servos? or i need to get special ones ??

 

[1NitroDude]

this work w/ normal servos? or i need to get special ones ??

It should work with normal servos. I had the traxxas steering servo #2075 on it when I had the traxxas slash. Thank you for your reply.

 

[ragedmx]

offer

consider my offer i have 100 dll

 

[1NitroDude]

consider my offer i have 100 dll

I'm sorry but the price is firm at $125 because I still have to pay for shipping costs. Thanks.-Joe

 

[1NitroDude]

Bump!

 

[ragedmx]

question..

the final price is 125 including shipping ?

 

[1NitroDude]

the final price is 125 including shipping ?

Yes it is.

 

[1NitroDude]

SOLD!