pelicanprentice
RCTalk Racer
- Messages
- 113
- Reaction score
- 10
I've got a savage x 4.6 and i picked up a 48t robinson spur gear and a 14t hardened clutch bell, i just tested the install a little bit (i wont get time till tomorrow to actually put it together) and it seems like the clutch bell is a tiny bit too small for the 48t spur gear. so i was wondering can i just put some type of spacers or something i find laying around under the engine mount bolts just to lift the engine a tiny bit so they mesh properly? or will this end up causing other fitment issue for other parts?
if its fine, do u have any recommendations on what to put under the engine mount just to raise the engine like 1mm?
thanks!!
if its fine, do u have any recommendations on what to put under the engine mount just to raise the engine like 1mm?
thanks!!