Another HSP-based build, this one on their "Flying Fish" pivot-ball onroad nitro with a Thunder Tiger Evo-12(P)
After a bit of hacksawing, sanding, and drilling, everything went together quite cleanly. I had to cut 5mm off the engine mounts to lower the engine so a bump box could reach it, drill out the flywheel to 6.35mm (1/4") bore, and extend the pilot shaft by 5mm with a shoulder bolt.
After a bit of hacksawing, sanding, and drilling, everything went together quite cleanly. I had to cut 5mm off the engine mounts to lower the engine so a bump box could reach it, drill out the flywheel to 6.35mm (1/4") bore, and extend the pilot shaft by 5mm with a shoulder bolt.