roadrunneruk
RC Newbie
Hi Guys recently purchaced a Baja 5B over the moon with it, I've got a couple of questions if someone can help with them.
The wheel assemblys front and rear axels there is a lot of play, most noticible when you hold the wheel theres a lot of slop, is this usual for the Baja and if so can it be corrected, I've notice on other manufacturers cars the wheel assembly axels are solid and have no flex in comparison.
The rear wheel toe in is set with a lot of neg toe in again is this normal for the Baja, there appears to be no means of adjusting the rear end toe in/out.
Lastly I'm running the car rich and bogs a lot, but now theres been a few tanks gone through I want to start leaning it out, can someone run through the low and high settings, my presumption is the low is for idle and high for top end simular to a glow engine, just want to make sure I've got it right before burning holes in the piston.
Many thanks
Darren
The wheel assemblys front and rear axels there is a lot of play, most noticible when you hold the wheel theres a lot of slop, is this usual for the Baja and if so can it be corrected, I've notice on other manufacturers cars the wheel assembly axels are solid and have no flex in comparison.
The rear wheel toe in is set with a lot of neg toe in again is this normal for the Baja, there appears to be no means of adjusting the rear end toe in/out.
Lastly I'm running the car rich and bogs a lot, but now theres been a few tanks gone through I want to start leaning it out, can someone run through the low and high settings, my presumption is the low is for idle and high for top end simular to a glow engine, just want to make sure I've got it right before burning holes in the piston.
Many thanks
Darren