throttle

i have been having a issue with my throttle post it keeps flipping backwards. This is what it should look like and this is what it always does do i need a new one or is their something i can do to stop it. Iv tried to adjust everything

I am new to nitro, and am having a problem with the trottle of my x-terminator, it requires a nudge to engage, it is sticking, any solutions?

ok i broke the screw mounts on the traxxas servo cap therefor it will not mount the the trucks mounts... is there a way to buy just the servo cap or do i have to but another brand new servo just for the cap?

Just as the title says. Whenever I give my truck throttle the engine cuts out. However if I leave the glow igniter on the truck and give it throttle it runs fine. Whats the dealio? I might add that I have pulled the glow plug and it turns red hot and looks brand new so I know it isnt bad.

I havent started my nitro engine for about 5 years now.. i just dug it up in the attic and tried to start it (with 5 year old gas) it started up fine and runs but immediately the car jumps to full throttle at the start. the servo is in the brake position and the throttle is pushed all the way...

howdy yall i am new here an new to tuning my s-maxx but can drive the wheels off anything:hehe: anyway i just got a s/maxx today an it seems to run pretty good other than it cuts out an dies on full throttle take off an a roll on full throttle i have tuned it to the best of my ability with out a...

i Have a savage Xl .it has good resopnce and fair speed from mid to top end but my off the line throttle sucks it boggs out realy bad tryed leaning out and richening up low end needle can anyone guide be better thank you

I am not getting a very good throttle response when I hit the gas. My buggy does a double take, then takes off. What is the problem and what should I do to get a clean response?

Hi, I just got a real cool looking Extreme Racing Throttle Mount Kit and I was wondering how do I mount my throttle return spring to it? Thank You, any input would be appreciated!:)

My throttle servo died. if you tap it it will work for a minute then stop. Checked it with the reverse servo just to make sure. Should i just replace it with the stock Traxxas servo or should i buy something better? Thanks

my losi aftershock the throttle and brake wouldnt work so i opened up the reciever box and pull the thorttle connector to check voltage and it was fine plugged it back in and now steering trottle and brakes dont work please help

Bad batt pack? I've got the rechargeable 5 cell for the on-board batts. Anyway. The steering doesn't work very well. It hardly does anything, even with the wheels in the air, not running -tipped up. The servo moves a little, but not much.. Just installed the servo-saver kit and the posts are...

hey guys i got the ss kit built and broken in but noticed that when i am driving it and let off the gas, i have to hit the brake for the throttle to come back to idle. it doesn't stay all the way open, not even a quarter of the way. i'm wondering what it is that's causing that. i have the...

Hey all, ansmann virus 1/8th buggy RTR. Recently, throttle servo has been jittery when at full throttle, and will not let me go, its a brand new servo, is it the batteries? or the stopper on the throttle levers? Need an explanation, thanks guys Matt :\

i just got my truck back together and trying to tune it. i was driving it around a parkinglot and and it would let me do full throttle then it lets off on its own and kinda flutters around back and fourth. i replaced the batts in the car it didnt seem to help and the light on my remote is still...

How do you use the 70/30 throttle control on the remote? Tried to reprogram into race mode and sport mode and it will not work?? Anyone else have this problem or know how to change it to this mode? I own a Traxxas E REVO ... Servo is a EVX/2

Ok. So I'm a noobie to Nitro so go easy on me. ;) I just got a T-Maxx 3.3 used from a guy I work with. I've been reading the manuals and support docs on line. I checked the setup the guy had and it was actually stock, so I decided to trying and tune it. My question is... after a hard...

Hey guys I'm building a 3.3 that I got in parts and I'm doing the final touches with everything before I fire it up and I noticed that the throttle isn't opening all the way up. I have an integy throttle arm on it with brand new bearings and its only opening up the carb halfway. What hole...

Hi I just picked up a Hitec 7940TH for my throttle/brake and I use an older model Hitec 5955tg for my steering.I want to know if anyone knows if I should just get me another high voltage servo for my steering since the H.V. one can handle a 7.4 volt battery compared to the 5955tg can only handle...

I have a nitro tmaxx truck I just recently got. Worked for a few weeks and was loads of fun but one day when I started it it instantly went wide open throttle but didn't go anywhere. Don't know much about these trucks so I'm kinda stuck. I've tinkered with it a little but I still can't figure it...