- Thread starter
- #41
Having a hard time getting these off to open it up…taken the little hex screws out but can’t get to the Phillips on the insideNo worries. To be honest you really should tear apart the trans. And the whole truck. Before you put power to it.
Make sure there is enough grease and proper alignment of the gears in the trans. Clean all the bearings and drive parts.. Or you could end up destroying it with the first battery. Amd pull of throttle..
The trucks probably been sitting around for a while. And could probably need a good cleaning and restoration before playing with it. You can find out alot of what you need with going over it before you power it up..
Any old truck or car I restore or pick up. I always start with breaking it completely apart. And go over the whole truck/car. Make sure everything is lubed and grease properly...
And a tip with the white plastics. To get them white again or close to white. The best way I found is with hydrogen peroxide.