I hit a pole earlier today at about 15-20 mph which brought my Revo 3.3 to a complete stop. It ran fine for about a minute afterwards and all of a sudden just died on me. I was giving it half to 3/4 throttle and the truck just shut off. Which has never happened before. The truck has a good tune and all.
Anyway, when I went up to it and rolled it forward a little, I noticed a clinging sound, almost like a little bell noise and the truck will barely roll forward.
The crank shaft (clutch bell gear) and spur gear will spin but the flywheel does not move at all.
So my guess is that something within the clutch bell is broken which causes the flywheel not to spin. Does this sound right? So basically I will just need to replace whatever broke in the clutch bell?
Also, when I tried to start the truck up again, it started rolling forward on its own and would not completely start.
Anyway, when I went up to it and rolled it forward a little, I noticed a clinging sound, almost like a little bell noise and the truck will barely roll forward.
The crank shaft (clutch bell gear) and spur gear will spin but the flywheel does not move at all.
So my guess is that something within the clutch bell is broken which causes the flywheel not to spin. Does this sound right? So basically I will just need to replace whatever broke in the clutch bell?
Also, when I tried to start the truck up again, it started rolling forward on its own and would not completely start.