mcvickj
Hardcore RCTalk User
Recently I cleaned off the dust on all of my old RC equipment and realized the engine for my HPI Savage was in a baggie all disassembled. Couldn't remember why until I started fiddling around with the bearings and realized they were pretty rough. Ordered some new bearings from Fast Eddy and getting ready to reinstall them but I have a question first.
For the rear engine bearing which side should be facing towards the rear? In the second picture I can't tell if this is some kind of shield that should also be removed before installing.
or
Here is the exploded view of the engine.
I also have a replacement for the front engine bearing. Both sides were rubber sealed so I just removed one side with a pick and will put that in towards the rear.
For the rear engine bearing which side should be facing towards the rear? In the second picture I can't tell if this is some kind of shield that should also be removed before installing.
Here is the exploded view of the engine.
I also have a replacement for the front engine bearing. Both sides were rubber sealed so I just removed one side with a pick and will put that in towards the rear.