Zvi
RC Newbie
Hi,
In the process of rebuilding my Ranger 1800 after a quite bad crash and I need some advise. It may sound odd but this is what I am experiencing.
The rudder and nose wheel are controlled by two different servos and there is a y-type cable that you connect the servos to so a single connector is connected to the receiver (or via the flight controller).
I had to exchange the servo controlling the nose wheel and I used a normal micro servo 'made in China' and modified the plastic connector so the nosewheel pin fits into the plastic actuator arm.
Unfortunately, when I move the rudder right, the nose wheel moves left and visa versa. I know it sounds weird but I have a video of this. My instructor is also quite at a loss for a fix.
Has anyone experienced this or can give me some guidance?
Thanks.
Zvi
In the process of rebuilding my Ranger 1800 after a quite bad crash and I need some advise. It may sound odd but this is what I am experiencing.
The rudder and nose wheel are controlled by two different servos and there is a y-type cable that you connect the servos to so a single connector is connected to the receiver (or via the flight controller).
I had to exchange the servo controlling the nose wheel and I used a normal micro servo 'made in China' and modified the plastic connector so the nosewheel pin fits into the plastic actuator arm.
Unfortunately, when I move the rudder right, the nose wheel moves left and visa versa. I know it sounds weird but I have a video of this. My instructor is also quite at a loss for a fix.
Has anyone experienced this or can give me some guidance?
Thanks.
Zvi