- Messages
- 551
- Reaction score
- 908
- Location
- Western Washington
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
I did a brief search and didn't see a thread so here is my question.
How are you leveling your bed? I recently started doing test prints and actively adjusting the bed as it's printing until I get the layer I like. Then I kill the print and use a feeler gauge to check the nozzle to bed height and note it on the filament box and in a file I keep.
Would it be easier to just use a consistent height and setup material profiles with different Z offsets?
Sorry if the question doesn't make sense. I'm still pretty new to printing and just trying to figure out the easiest way to do stuff. I'm asking here because we are printing similar things as opposed to a lot of the groups I've looked at where how to best print a vase may not apply to how to print a bumper or set of wheels.
How are you leveling your bed? I recently started doing test prints and actively adjusting the bed as it's printing until I get the layer I like. Then I kill the print and use a feeler gauge to check the nozzle to bed height and note it on the filament box and in a file I keep.
Would it be easier to just use a consistent height and setup material profiles with different Z offsets?
Sorry if the question doesn't make sense. I'm still pretty new to printing and just trying to figure out the easiest way to do stuff. I'm asking here because we are printing similar things as opposed to a lot of the groups I've looked at where how to best print a vase may not apply to how to print a bumper or set of wheels.