base settings?

[dan14]

hi
I've just got myself the Hong Nor CRT X1 rtr racer http://www.jespares.com/catalog/product_info.php?cPath=377&products_id=2764
and the engine is a force 28 engine with a 2 carb and what is the base settings for it
Cheers Dan

 

[nicholas655]

try the manual, it should be in there somewhere

 

[dan14]

I've looked but it just tells you about the car? and could you use the base settings off a hpi engine with a 2 carb?

 

[nicholas655]

I've looked but it just tells you about the car? and could you use the base settings off a hpi engine with a 2 carb?

here maybe this might help
http://www.rc411.com/reviews/jamx1crt/specifics.pdf
not ssure if i ts the right one but check it out

 

[dan14]

no problem any cheers for the help tho

 

[olds97_lss]

I got this from the OFNA Ravager manual, it has the Force 28:
http://www.ofna.com/pdf/34957-ravager.pdf

NEEDLE SETTINGS
Master Needle Valve - main control for fuel mixture. Set at 3 to 31/2 turns from closed. Adjust this needle for
maximum RPM and power without being too lean or too hot. Make sure you start at bottom of needle seat!!

Side Carburetor Needle (Low Speed) - This needle is in the center side of the carburetor and provide throttle
response. It is not the idle adjustment. Set FLUSH with the brass sleeve. Turning in is Lean and Out is Rich. Do
not adjust this needle until the Master Needle is set for power and top speed. This will only effect throttle response.

FOR THREE NEEDLE CARBURETORS, DO NOT ADJUST MID RANGE NEEDLE, PRESET BY FACTORY
Barrel Stop Screws - Used for adjusting Idle. Set for 1/16th inch gap to start new engines. You can open more for
faster idle.

here maybe this might help
http://www.rc411.com/reviews/jamx1crt/specifics.pdf
not ssure if i ts the right one but check it out

That's for an OS 21 Vspec engine. Nice engine though...