I'm having a problem with my 74.1
The servo I have is from an rb10 I had sitting in a drawer. It's a reedy I believe.
What happens is when I get up to speed and try to give slight steering inputs it just JERKS and goes hard in that direction for longer than usual.
When it is sitting in neutral it responded just fine. Only at speed does this happen.
Its borderline uncontrollable.
Any ideas?
PS: I only used the rtr Rx and trans just to check for function. I am of course upgrading. I'm somewhat new and what to get a better understanding of what's going on
Also it's a reedy 1523 and I'm pretty sure I have the DVC on the RX off
The servo I have is from an rb10 I had sitting in a drawer. It's a reedy I believe.
What happens is when I get up to speed and try to give slight steering inputs it just JERKS and goes hard in that direction for longer than usual.
When it is sitting in neutral it responded just fine. Only at speed does this happen.
Its borderline uncontrollable.
Any ideas?
PS: I only used the rtr Rx and trans just to check for function. I am of course upgrading. I'm somewhat new and what to get a better understanding of what's going on
Also it's a reedy 1523 and I'm pretty sure I have the DVC on the RX off