I'm converting my Arrma Senton 3s to a Typhon 3s. (Or Syphon) After bashing for a few months I've noticed that my body is breaking so often because I land on it so much. I went to order a new one and realized that the Typhon body was about half the price. Looking at my cousin's Typhon body, he doesn't even have a crack in it because when he flips over it doesn't touch the ground. I decided I was going to get Typhon body mounts and a body. I'm getting bigger tires and a smaller pinion too. I'm hoping to save a little money on cheaper bodies and them lasting longer along with me liking the Typhon look more now. I'm planning on leaving the senton bumper on because it's bigger but changing the rear bumper.
Next I'll probably 3d print the rear wing (Thanks Camaroboy383 for modeling it) and the rear wing mount (Thanks suchtragedy). I might be 3d printing some bigger tires with big teeth for the dirt, not sure yet tho. Still have to model them and not sure how hard it will be since I just installed meshmixer last night as I have been using sketchup. Sketchup hasn't worked good for printing as it fills in holes in some layers and makes holes where it should be filled in.
Next I'll probably 3d print the rear wing (Thanks Camaroboy383 for modeling it) and the rear wing mount (Thanks suchtragedy). I might be 3d printing some bigger tires with big teeth for the dirt, not sure yet tho. Still have to model them and not sure how hard it will be since I just installed meshmixer last night as I have been using sketchup. Sketchup hasn't worked good for printing as it fills in holes in some layers and makes holes where it should be filled in.