Jonny1982
RC Newbie
- Messages
- 4
- Reaction score
- 0
Hi. I just bought a
1/10 2.4Ghz Exceed RC Infinitve Nitro Gas Powered RTR Off Road Monster 4WD Truck
I tried to follow the break in procedure to a tee. Wouldn't start after 3 hours of trying gave up. Next day, changed low speed needle a bit richer and got it started with throttle trimmed out all the way. I don't have a stand, so I hung it level with string from my lawn mower! Runs as long as throttle trimmed out (wheels spinning like crazy). Can turn throttle trim dial down a bit, but after so much (wheels are still spinning fast) it quits on me. Hard to get it started back up then, even with glow plug ignitor, takes several pulls. Ran a whole tank throung with throttle trimmed out, and still won't idle without throttle without shutting off. Plus, metal shavings seem to be all over truck, is this normal? Base settings of LSN and HSN are all the way clockwise, then 3-1,2 turns counter. The LSN is currently set to 4 turns counter, and the HSN is set to base (3-1/2) Does anyone have any advice for me to get this thing running right? Really excited to run this around with my son, but getting frustrated. Also, I am new at this, may not be using proper terminology. Thanks!
1/10 2.4Ghz Exceed RC Infinitve Nitro Gas Powered RTR Off Road Monster 4WD Truck
I tried to follow the break in procedure to a tee. Wouldn't start after 3 hours of trying gave up. Next day, changed low speed needle a bit richer and got it started with throttle trimmed out all the way. I don't have a stand, so I hung it level with string from my lawn mower! Runs as long as throttle trimmed out (wheels spinning like crazy). Can turn throttle trim dial down a bit, but after so much (wheels are still spinning fast) it quits on me. Hard to get it started back up then, even with glow plug ignitor, takes several pulls. Ran a whole tank throung with throttle trimmed out, and still won't idle without throttle without shutting off. Plus, metal shavings seem to be all over truck, is this normal? Base settings of LSN and HSN are all the way clockwise, then 3-1,2 turns counter. The LSN is currently set to 4 turns counter, and the HSN is set to base (3-1/2) Does anyone have any advice for me to get this thing running right? Really excited to run this around with my son, but getting frustrated. Also, I am new at this, may not be using proper terminology. Thanks!