ridgehead44
RCTalk Basher
Greetings and Happy Thanksgiving weekend all!
I recently bought an Axial SMT10 on sale for $200.00. I got to moding it before I even ran it. I added rear sway bars and a brushless system. It's just about ready to go on its first run, but I wanted to see if I needed to loosen or otherwise service the slipper clutch before running it brushless on 2 or 3S. I kept the stock pinion, which is 13 tooth if I recall correctly. I just don't want to blow out the drive shafts or chew up the spur gear right away after dropping a lipo in there. Any advice on this is much appreciated. Thank you!
I recently bought an Axial SMT10 on sale for $200.00. I got to moding it before I even ran it. I added rear sway bars and a brushless system. It's just about ready to go on its first run, but I wanted to see if I needed to loosen or otherwise service the slipper clutch before running it brushless on 2 or 3S. I kept the stock pinion, which is 13 tooth if I recall correctly. I just don't want to blow out the drive shafts or chew up the spur gear right away after dropping a lipo in there. Any advice on this is much appreciated. Thank you!