help needed for newbie

[converse]

hi - have got a HiSpeed RST NC365 - Fully Built Hot Lava Off Road Nitro Buggy - when i got it, it was missing a part - the dog bone on the front driver side, which should i think give power to the wheel. so i think at the mo it is three wheel drive.

i have got the required part and emailed company to ask how to fit it - there reply - " You would take the wheel off and then the knuckle arm off to install it"

well i managed to get the wheel off and took off the two silver screw in things (ball head cover and caps) but i can't seem to work out how to get the knuckle arm/hub off - i guess i need to remove the ball head screws? but have tried a alum key and phillips screwdriver to now avail.

any help would be much appreciated
thanks

[iphong]

could you post a picture of the knucles? knuckles is not that hard to deassemble. alternatively, you can remove the upper arm from the bulk head. most buggies, upper arm is held by a pin which locked by a e clip. e clip is very easy to be removed. once you take out the upper arm, just snap the dog bone in and put the arm back in place.

[jon2]

Ok I googled it and looks like this may be your rig..

http://www.amazon.co.uk/Blue-Radio-Controlled-HiSpeed-NC365/dp/B000KLRUG6/sr=8-1/qid=1168905035/ref=sr_1_1/026-1978217-5970069?ie=UTF8&s=electronics

http://www.amazon.co.uk/Blue-Radio-Controlled-HiSpeed-NC365/dp/B000KLRUG6/sr=8-1/qid=1168905035/ref=sr_1_1/026-1978217-5970069?ie=UTF8&s=electronics

It also looks like a 1/0th scale. Do you have a Manual to this?

[iphong]

i saw the picture. just remove the e clip, push the pin out and the arm is free.

[converse]

yes that the buggy shown on the amazon link is the one i have got

ok i will trying removing the upper arm

iphong u say the knuckle is easy to dissemble, how do u actually do it? use brute force or is there a way to unscrew the ball head screws ?

http://www.nitrotek.co.uk/products.php?cat=57&pg=13

shows the knuckle/steering hub/arm top rht hand corner

thanks

p.s i have now managed to replace the dog bone by removing the arm thing by removing the eclip - thanks iphong for advice - never did discover how to remove the knukle arm - don't think the co i got the buggy from gave me v good advice !

thanks