You're currently viewing the thread: Did I do this right?

pissant · #1 4-20-2005, 7:19 PM

Well when i put the throttle linkage on my vspec .21 engine. I had to take the carb thingy and put it on backwards so the throttle linkage didnt have to be the long. is this ok, its hard to explain, its the piece you can remove form the engine, where the LSN and the HSN is? I just had to switch it so the O.S. logo on it was facing the engine, would I have problems doing this? I have the mp777 if that helps :fro:

CorradoPsi · #2 4-20-2005, 7:29 PM

yes on most engines you have to rotate the carb for buggy use. the slide should be pointed towards the servo.

pissant · #3 4-20-2005, 8:30 PM

ok thanks, yea i thought so, lol

PiErow · #4 4-20-2005, 8:31 PM

Ya on 1/8th scale buggies you have to rotate the carb 180 degrees.

Plaidfish · #5 4-21-2005, 8:01 AM

Hey on 1/8scale buggies you have to rotate the carb....I just wanted to post that too

vbgagnon · #6 4-21-2005, 8:04 AM

Just in case you didn't know...you have to rotate the carb.

retarded pilot · #7 4-21-2005, 9:35 AM

forget what those hacks told you........you have to rotate the carb in a 1/8 buggy

CorradoPsi · #8 4-21-2005, 1:20 PM

wheres lessen, he needs to get in on this...............

beason · #9 4-21-2005, 1:24 PM

hey man im not sure but i think you may have to rotate the carb if your gonna be putting it on a buggy.. im not sure.. i may be wrong.. just thought i would post that since NOONE else has..

wannarunem · #10 4-21-2005, 1:39 PM

hey pissant dont take all this shit from them...tell em to sit on this and rotate....

LMAO!!!!!!!

start at post #20 in this thread...it may help ya.....

http://www.rcnitrotalk.com/forum/showthread.php?t=29030

bsodmike · #11 5-08-2005, 12:40 AM

I just figured that today my self. Now in the Kyosho manual it shows the ball link facing down-forwards, but mine is up-backwards (towards the rear)...can this be moved?