Rubbing on the PCR Pro

[jon2]

Ok I decided to change the c hub in the front to the PBS style. I am not too happy already with the directions with this kit but now I can't seem to steer at all!! The Upper anti squat is rubbing on the aluminum sttering bar that holds the turnbuckles. I am pretty pissed already and I need you PCR pro owners some help. what the hell is wrong?

[jon2]

Help

[itsme]

That was one of my problems with the POS Violator i Have it already has a weak servor so rubbing on that plastic stop didnt help one bit my next buggy going to have PBS.

[dgrobe2112]

i think you need to change shock tower.. and chassis braces.. front steering brace as well.. big difference between the PBS, and C-hub.. also your arms will be different as well..

just wanted to make sure you knew that before you tried to pull of the c-hub and put the pbs on there..

[jon2]

I figured it out. I had the hinge pins on the wrong hole . PLus I went ahead and countersunk the screw and inverted the screw so it would be flush into the counter sunk hole. Lol I screwed that one. Still not happy with the instructions.

[itsme]

Im Going to try putting the MBX front and rear section on the Violator its not going to be as wide as it was but im not to concerned about that i just want something more durable IMO
so to sum it up im going to have a MBX Violator. Have A Nice Day:cheeky:

[jon2]

OK I did all that and I still feel some binding somewhere and am not sure where to look. The binding casued my srevo --645mg to strip the servo . I also tightened the spring on the steering assembly. SHould I have done that? Where else can I look? I am really getting tired of this buggy. No drive time yet!!!

Steering Servo arm I meant. Lol