Go Back   RCNitroTalk > R/C Forums > 1/8th scale Buggy


You're currently viewing the thread: Stalling issue

Located in the 1/8th scale Buggy forum.


Thread Tools
  #1  
Old 3-20-2004, 3:08 PM
golfinglenn
Status: Offline
RCNT Basher
 
Join Date: Feb 2004
Posts per Day: 0.03
Trader Feedback: (0)
Stalling issue

I have a friend that has an Ofna MBX that likes to stall at about half tank and then he cannot get it re-started unless he re-primes. He thinks maybe his lid on his fuel tank is leaking and allowing air to escape thus losing pressure and causing fuel starvation. Anybody else run into this or is it a common problem with the fuel tank?

Thanks,

Glenn
Reply With Quote


Alt Today
Advertising  
Register your free account today
to remove this box!
Standard Sponsored Links

  #2  
Old 3-20-2004, 3:17 PM
Diver6127
Status: Offline
Hardcore RCNT User
 
Join Date: Sep 2003
Posts per Day: 2.23
Trader Feedback: (6)
Check the fuel lines for air leaks as well as cracks in the gas tank. Might be causeing an overheating situation. Check the engine with a temp gun too.
Reply With Quote


  #3  
Old 3-20-2004, 9:06 PM
militarymaxx
Status: Offline
Hardcore RCNT User
 
Join Date: May 2003
Location: Littleton, NH
Posts per Day: 0.43
Experience: I am an experienced RC driver
Trader Feedback: (0)
Yup, Diver is right. I had a similiar situation where as the buggy warmed up it developed and air leak, proabably due to expansion from the heat, around the banjo fitting on the carb. Not only did it run lean because of the added air, it would flame out and starting was very difficult. As it cooled down it would fire right up and run good until the process repeated itself. Fuel line is cheap. When in doubt, replace it. Seal that engine up, carb and all. And like Diver suggested, get a temp gun/monitor.
Reply With Quote


  #4  
Old 3-20-2004, 9:34 PM
golfinglenn
Status: Offline
RCNT Basher
 
Join Date: Feb 2004
Posts per Day: 0.03
Trader Feedback: (0)
Cool, I will have him check those things. I have a temp gun so we will do that as well. I am pretty sure he seals his backplates and carbs routinely, but will check that as well as replace the fuel lines. I just ordered a 50' roll of fuel line from tower, so I think I can spare some.


Glenn
Reply With Quote


Post Reply

Bookmarks



Thread Tools

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Windows XP Driver issue. FastEddy General Chaos 7 5-26-2006 10:53 PM
Monster GT Transmission ? Issue FastEddy Associated Monster GT 5 4-23-2006 9:43 PM
Printer issue or mouse issue? FastEddy General Chaos 13 4-29-2005 4:12 AM


All times are GMT -5. The time now is 9:55 PM.

Copyright © 2008-2009 RCNitroTalk, All Rights Reserved
Powered by vBulletin®, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
Our Community
Latest Forums Topics
About RCNitroTalk
Need Help?
Page generated in 0.80926 seconds with 18 queries