your photo is no longer there i have a picco max 0.26 and need to change the ball bearings in the motor inner and outer but the LHS do not carry and can not order the needed parts was wondering is anyone hows a company that has the bearings i need the inner is 13x24x6 and outer is 7x17x6 thx
last race season i was using 30% from morgan ran great with a poop load or punch now i replaced the revo with a 1/8th buggy for racing and now in the picco i use 20% for bashing runs great and a little easier to tune now with the 20% from morgan just ordered all new bearings for the motor and...
hello i have the same setup a revo 2.5 with a picco 0.26 the one way bearing is the same and the ez start will go on with ease just need the Ofna motor mount other that i added a Trinty pipe runs great but not good for a city truck sure added power but that pipe is super loud.
Ok heres the deal I burnt the 3.3 a while back the connecting rod snapped and the piston fell apart. So i ordered all the parts and replaced everything I toke it out and broke in the motor and after the break in a day or two later i thought id bring it out and do some fine tuning got her outside...
OK hooked up the ez start back on the revo today but wanted to know where is thr best place to put the ground wire and should i remove the glow plug wire?
OK after waitin for the parts for my truck and a nice day i get outside to go for a test run and my pull start will not come out it went in and will not move at all HELP PLZ
Did that I just put a new glow plug in 20 min earlier
glow warmer starts my 2 other trucks and starts my tmaxx 3.3 with ease but as soon as i remove it the truck stalls
its a brand new low plug and no maybe a little pink but in no way not all the way red
i think you are right think you are right today i toke it for a spin and just tapped a tree and broke the front arm and snapped the gear of the servo and just now went and bought all broken parts got it...
thought so just i went to traxxas and looked i have a 72 pin in now its a high Torque spur gear should i keep its the same or change for more or less pins and can i get a metal spur gear
Truck revving up great everything is turning when i reve but the black disc in the middle its a disc with hole all around has a ball bearing and s shaft running thou. looks to me the teeth are worn down alot only thing is I'm not sure what it looked like before and can't look it up as i dont know...
OK heres the deal today i toke my T-Maxx 3.3 for a spin and just tapped a tree and broke the front arm and snapped the gear of the servo and just now went and bought all broken parts got everything installed reunning great so i go outside for 10 mins and now i get it running on 1st or 2nd pull...